H20 Series

20 ton Hydraulic Bridge frame machine from the 90s.  Originally used the Macintosh/ or PC controllers, however some were updated to the Fanuc controller.  The machine becomes a good solid reliable machine with the new controller.  Problems with ram control would make this machine problematic with forming strokes to precise depths.  Machine used the Industrial Clutch HI LO ram.  Lately problems with supply of the Ram Control Module also make this machine hard to repair.

Common Part List 

*Select link to go to product

Sensors

Reposition Cylinder Retracted Sensor

Auto Index Retract/Extend Sensor

Auto Index Brake Sensor

Shot Pin In/Out Sensor

Indexable Multitool short tool Extended Sensor

Work Clamp Scan Sensor

Hood Door Closed Switch

X,Y,T Reference Switch

C Axis Home Sensor

 

Servomotors

X Axis Servomotor

Y Axis Servomotor

T Axis Servomotor

C Axis Servomotor

X,Y Servo Amplifiers

C,T Servo Amplifier

Air Cylinders

Reposition Cylinder

Shot Pin Cylinder

Mutiltool Short Cylinder

Mutiltool Long Cylinder

Auto Index Spindle Cylinder

Auto Index Brake Cylinder

Work Clamp Closed Cylinder

Side Gauge/ Center Gauge Cylinder

Work Clamp Parts

Lower Jaw

Upper Jaw

Work Clamp Body

Clamp Stop Bar Set

Work Clamp Target

T-Nut Metric

Work Clamp Ratchet Handle Metric

Turret Parts

3-1/2(D) Bushing LT

3-1/2(D) Bushing ST

1-1/4(B) Bushing LT

1-1/4(B) Bushing ST

Auto Index Bushing D LT

Auto Index Bushing D ST

Station Key D LT

Table Brush Assy