S machine J Frame
The S Series machines machined in 2 pieces the permanently joined to become one piece J framed machines. These machine utilized the 33 station turret, and the 2 servo auto index was a superior design. Considered by many as a reliable, we'll designed workhorse. Parts support is good, and there were a few variations, 40", and 50" throats, and 65", and 80" X travel designs. The machine utilized 3 different controllers over the years. Fanuc OPB and OPC, and a few PC controlled machines also shipped. The PC machines are to be avoided because of an obsolete, unsupportable Strippit® controller.
Common Part List
*Select link to go to product
Sensors
Work Clamp Protect Small and Large Sensor
Turret Slow/Reference Sensor Early Machines
Turret Reference Sensor Later Machines
Auto Index Engage/Disengage Sensor
Index Station Recognition Sensor
Multitool Retracted Switch Long Tool
Multitool Retracted Switch Short Tool
Yellow Mushroom Side Gauge Button
Servomotors
Air Cylinders
Auto Index Brake Release Cylinder
Work Clamp Parts
Work Clamp Ratchet Handle Metric
Work Clamp Ratchet Handle Inch
Turret Parts
Sensor Proximity 8mm NO PNP Shot Pin includes cable
(Replaces Strippit® Part Number 19940-000)
Cylinder Pneumatic S,H Workclamp
(Replaces Strippit® Part Number 803240-000)
Rotary Union Hyd.
Replaces Strippit® Part Number 802501-000
Replaces Strippit® Part Number 210380-000
Cylinder (Shot Pin Sub Assembly) retrofit kit
Replaces Strippit® Part Number 800486-000
requires 4 pcs.
Brake Disk lined Hyd C/B Good Used Sold individually
Replaces Strippit® Part Number 802503-000
We sell them individually for your convenience. Keep in mind the outer disk in the PAK is normally ground to adjust the thickness of the PAK. Do not replace this without grinding to makeup original thickness. Typically just replace worn disks within the PAK or pads that have been damaged.
Clutch Plate Hyd C/B 30 ton
includes 6-M10 x 25mm SHCS, and Retainer Washer
(Replaces Strippit® Part Number 802994-220)
Seal Outer Cover Hyd C/B
(Replaces Strippit® Part Number 802499-000)
Request quote at Parts@CNCMachineryLLC.com
Body Workclamp UPPER 2 piece ( includes metric, and inch hardware)
If you only need the lower body see my part number MH6SCP-47
(Replaces Strippit® Part Number 119896-200)
Bearing Work Clamp THK HSR 25 with 100 mm rail
(Replaces Strippit® Part Number 803244-000)
Sensor Proximity Quick Connect
NPN NO, includes cable
Feed Start, Punch End early S, 1000/3, XT, FANUC
(Replaces Strippit® Part Number 801051-000)